Unikit DIP
ARM Development Made Easy
Unikit DIP is a 66 pin DIP package containing a popular ARM7TDMI-based processor, all required power supplies, LEDs and an (optional) ICE connector. It is an easy-to-use board for students wanted to design their own hardware using the ARM processor.
Unikit DIP was developed in associated with Canterbury University. It is available in quantities of 20 or more at cost to educational institutions such as schools and universities.
A PDF brochure is available.
Features
- 16/32-bit ARM7TDMI-S micro controller
- 16kB on-chip Static RAM
- 256kB on-chip Flash Program Memory. 128-bit wide interface/accelerator
- In-System Programming (ISP) and In-Application Programming (IAP) via on-chip boot-loader software
- Embedded ICE-RT interface enables break points and watch points
- Interrupt service routines can continue to execute while the foreground task is debugged with the on-chip RealMonitor software
- Embedded Trace Macrocell enables non-intrusive high speed real-time tracing of instruction execution
- Two interconnected CAN interfaces with advanced acceptance filters
- Four channel 10-bit A/D converter with conversion time as low as 2.44 us
- Multiple serial interfaces including two UARTs (16C550), Fast I2C (400 kbits/s) and two SPIs
- 60MHz maximum CPU clock available from programmable on-chip
- Phase-Lock Loop with settling time of 100 us
- Vectored Interrupt Controller with configurable priorities and vector addresses
- Two 32-bit timers (with four capture and four compare channels)
- PWM unit (six outputs)
- Real Time Clock
- Watchdog Timer
- Up to forty-six 5V tolerant general purpose I/O pins. Up to nine edge or level sensitive external interrupt pins available
- Two low power modes, Idle and Power down
- Processor wake-up from Power-down mode via external interrupt
- Individual enable/disable of peripheral functions for power optimisation.
- Dual on boards power supplies: CPU operating voltage of 1.8V, I/O power supply of 3.3V with 5V tolerant I/Os